I have a 2017 YZF-R125. I've had it for about a year, and sometime this fall, the valves started clicking loudly. I've already been to the garage for service, and they said it's normal due to the valve clearance. But I'm still wondering if there's anything that can be done about it, or if it's actually good for the bike. When I ride, especially without a helmet, all I can hear is the engine rattling.
(1 votes)
Loading...Good day, I'd like to restrict my KTM 620 LC4 Supercompetition for A2. It has approximately 65 hp when open and weighs just under 140 kg. How many kW/hp do I need to restrict it to? There are many different restrictors, some with more and some with less power, and some with certificates. Usually between…
A colleague's moped occasionally just dies. It sputters for a moment and then dies. But it starts right back up after a couple of kicks. It is a Riju mrt 50 Low Euro 4 with about 5000km. Does anyone have any idea what could be causing this? Thanks in advance!
Hello, I went to the TÜV and the following significant defect was discovered: Wheel house inner panel above drive shaft 1st axle right loose with danger of falling off. The vehicle is a Volvo V70 II D5 diesel with 185 hp (2401 cm³) and 6-speed manual transmission. I took a few photos of the fairing…
Hello, I bought the angel eyes from sickmotos, the UNI V5. They were supposed to be the brightest, but I was stopped by the police who told me they weren't legal, even though they had an E-number. What should I do now?
Hey, I've been wondering for a while whether it's legal to remove the DB killer from a Euro 4 exhaust system, in my case the Remus Black Hawk for the 701 2020, and secure it again with a screw? The DB killers have to be welded in at the factory. Will my operating license be…
have you felt anything about less power, less power, or is everything like before?
if valves have too much play, the compression and thus the “power pressure”.
The performance is as far as I know as before, I mainly disturb the loud noise when driving