I used the indicator and noticed that my driving light was getting darker and darker and as soon as I turned off the indicator it would get brighter again
After using the indicator again, my headlights went out completely. What could that be?
Vehicle type qingqi scooter qm50qt-6a
(1 votes)
Loading...Have a good meal , I've had a bike for a while now and I've had the following problem with it: when I want to ride and pedal, the rear sprocket that the chain is on (hub gear) just turns and the wheel doesn't move. But if I put it upside down and there's no…
Hey, the speedometer in my car is completely wrong. Even at 50 km/h measured with GPS, it shows 57, which is way too high. I have a 2015 Ford C Max. Can something be done about it? I would like it to be accurate to the km/h. Thanks
Hi, what happens if I operate a 2kv capacitor with 2.5kv?
My motorcycle tipped over while I was out riding. Because of my limited technical knowledge, I'm not sure exactly what broke. I couldn't start it (clutch + starter) until I connected the two parts. My question: Is this a problem? Can I fix it myself?
I bought a monitor about 2 months ago ( https://www.amazon.de/gp/product/B0BNGML1TQ/ref=ppx_od_dt_b_asin_title_s00?ie=UTF8&psc=1 ) I believe it arrived in good condition, but at the time I didn't realize that the product had probably been damaged in transit. The monitor has a small flaw in the upper right corner of the screen that I didn't notice. Well, about 2…
Hello, my moped has no power, or rather, it's very weak. I've cleaned the carburetor several times.
3 possible causes can be mainly:
Battery can simply test either load and try again or you let the engine run and then clamp the mass. If everything goes normal, the battery is back and generator with rectifier.. are OK.
If the engine goes out with a clamped mass, the generator, rectifier, is defective.
I guess that’s not enough for the charging power of your LIMA to supply the on-board power properly.
Do you still have the original lamp in the headlight?
Is the original in yes
Ok then there’s some mistake in the controller or the Lima
Mass problem. Clean and screw the connectors on the frame.
It usually fits when you’re standing with the scooter.
Then the current is not enough for both