How many amps does this pump need?
How many amps does this pump need?
Will it work if I use a 12V 10A DC power supply?
(No Ratings Yet)
Loading...
(No Ratings Yet)Loading...
(No Ratings Yet)Loading...Similar Posts
Why does my stepper motor vibrate and not rotate properly?
My stepper motors aren't working properly; they rotate strangely and vibrate loudly. I have three different ones (20 Ncm, 45 Ncm, 59 Ncm). The first two vibrate strangely and don't rotate properly. Sometimes they rotate in the wrong direction, stop, or continue, or do nothing and just vibrate. The 59 Ncm motor works perfectly, however,…
Bicycle conversion kit E-Bike?
Hello, I own the Focus Vice Factory 2017 and I would like to buy a conversion kit so that I can convert my bike into an e-bike. The only problem is, my wheel size is 27^ and there is no conversion kit for 27 inches… only 26/28 or something else. Is there a conversion kit…
W124 alternator broken?
Bytxk83
In my W124, the battery and apparently the alternator regulator were broken. After I replaced both, the battery dropped to 13.5 V at idle. Now, after an hour of driving, it's only running at 12.5 V at idle, and at 12.2 V when the engine is off. Is the entire alternator broken?
Where can you find double-sided adhesive tape in specialty stores?
I need adhesive strips that stick in both directions to attach a small battery to the case. If I had to estimate, I'd estimate the width to be around 0.2-0.5 mm and the length to be 1-2 cm. It has to be that long; anything larger probably wouldn't fit. Which stores offer something like that?…
Got an electric shock?
ByErere982
Yesterday at 10:30 p.m. I pulled the USB plug out of the socket and plugged in a new one, then plugged in my phone. There was no bang, nothing, but afterwards my hand started tingling and my arm became so heavy that it lasted for an hour or so. Today my arm still feels weird…
Operate LED lamp on power bank?
ByKlaus818
Hello, I want to use an LED light (USB connection) on the go. It works perfectly on my laptop, but with the power bank (24,000 mAh) it only glows very dimly. This can't be due to the power bank's performance, can it?! Who can help me? Thank you very much. Klaus
The pump requires a maximum of 12V / 5A (=maximum 60W).
The data sheet:
https://asset.conrad.com/media10/add/160267/c1/-/gl/000552372DS01/datasheet-552372-comet-ocean-softstart-12v-11049259-lower-voltage dip pump-1260-lh-15-m.pdf
Conclusion:
YES, a 12V DC 10A power supply is enough.
I would use a power supply with at least 6A so that the power supply is not operated in the interface (100% full load). A power reserve is then “heavy” for the power supply.
Good luck!
The data sheet is 5 A maximum.
See data sheet. There the maximum current is shown at 5 A. The power supply is therefore loose enough, which can be loaded up to 10 A. This allows you to operate 2 of these pumps simultaneously.