Why does my scooter's kickstarter block?
Hello,
Today I removed the variator cover on my scooter to install a new seal. Everything worked. Then I tried to screw the variator cover back on, which also went smoothly. However, I noticed that the kickstarter wouldn't move. So I removed the variator cover again to see if I'd done anything wrong. There was nothing obvious. The kickstarter won't move at all. Not even when force is applied. Now I'm wondering why the kickstarter is jammed. Do you have any idea what could be causing this?
(1 votes)
Loading...
Possibly, the toothing of the gear wheel holding circuit on your left image does not sit correctly in the gear wheel of the driver (on the right side)
This should be easy to move when the lid is open…
Unfortunately, the gear cannot be moved
Maybe the feather has wedged…
The driver should be pulled off, then you can knock half the gear with a rubber hammer out of the housing…
Or turn on the driver, there’s something…
But you need the lever of the kickstarter, because the feather already has strength, you may not turn so easy…
I have now tried to solve what was also not possible. Otherwise, nothing can be moved. So I’ll go to the workshop soon. What would interest me, though: The gear has probably been dry for months. Well, there’s been no fat anymore. Could it be that this is the reason for blocking or does it have nothing to do with it first?
No, there’s no need for fat. But you can write something in…
It’s just not allowed to get into the centrifugal clutch…