Washing machine suddenly stops drawing water?

My washing machine was washing its second load of laundry for the day, and at some point it jumped upright. It's never done that before. Now the light is flashing, telling me to check the water inlet. The faucet was turned on, and the strainer in the hose wasn't clogged. Does anyone know how I can get it working again?

1 vote, average: 1.00 out of 1 (1 rating, 1 votes, rated)
You need to be a registered member to rate this.
Loading...
Subscribe
Notify of
13 Answers
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
treppensteiger
6 months ago

"Shooved with swing" is more likely for a motor or drum blockage. The water problem would then be only the result, due to the destroyed sensor system or valves, wire breakage or the like due to the violent blow.

If the drum is available at the top loader, at the front loader I am not sure, unusually easy to turn by hand, the belt that transmits the rotary motion from the engine is slipped down. However, this would also be seen only one of several errors and only as confirmation for drum or motor problems.

Most likely a repair is necessary.

treppensteiger
6 months ago
Reply to  Fluffx888

Okay, then maybe there's a wire off or something. It is amazing that the machine is completely rendered incapable of tax despite an error display, for example, and not (from programming).

JesJu
6 months ago

Hello Fluffx,

yes Pull plugs and plug in after 10 minutes and see if the machine starts.

Or do the reset with the machine.

LEG

JesJu
6 months ago
Reply to  Fluffx888

Only the customer service helps, seems to be a problem with electronics.

timerstyle
6 months ago

Hello Fluffx,

Are you listening to the magnetic valve as soon as it should pull water?

Greetings;)

timerstyle
6 months ago
Reply to  Fluffx888

Either the solenoid valve is defective, it usually sits under the upper lid at the water inlet or the hose is blocked

timerstyle
6 months ago

This is possible, but it is not a witch's work to exchange;)

mudda405
6 months ago

Did you turn the inflow cock?