Was würde passieren wenn ein Triebwagen einfach an einem anderen ankuppelt?
Ja wie hier im Bild hält ein Triebwagen hinter dem anderen weil das Gleis für Zwei Züge geteilt ist. Was würde jetzt bei dem Anderen Triebfahrzeugführer passieren wenn unserer Triebwagen jetzt einfach Langsam auf den anderen Triebwagen zufährt und sich ankoppelt
ohne dass der andere TF davon was weiß? Ich denke mal die Scharfenbergkupplungen werden sich trotzdem miteinander verbinden und die Elektrischen Kontakte auch. Aber bekommt der TF das überhaupt mit weil der Triebwagen bedfindet sich ja nicht im Kupplungsmodus. Steht dann da Störung oder sagt der Triebwagen perfekt jetzt fahren wir Doppeltraktion?
(1 votes)
Loading...
I assume that the vehicles are connected mechanically and electrically. However, since the electronically supported communication between the controllers of the two or more vehicles does not begin by itself, the driver of the leading vehicle, i.e. the foremost driver’s cab, must be initiated. The technical tensile data changes. Length, braking weight, mass and controls of the “hanged” vehicles must be put into the takeover mode so that all vehicles react the same. The operation and monitoring of the PZB or ETCS and the SiFa are only active in the manned leadership. The newly created train then also has to take over a new train number so that the service managers of the control units can address this train in a targeted manner.
This looks like an extension. Or wing train.
Ne they are 1 meter separated
The notices that the new train configuration must be confirmed (“cocked”).
Basically: If the clutches fit and have no Parisian:
https://flic.kr/p/2q4ma7c
And they can automatically dome is mechanically coupled.
Electrically depending on whether due vehicles are compatible.
Stadler KISS and FLIRT can be combined in Luxembourg.
https://flic.kr/p/2i5ucCg
Depending on the control, a train notices when what is coupled and integrates the one in the controller.
However, this can be different from vehicle to vehicle.
Here is the half-hour dome maneuver in Spiez, where it is coupled in 3 minutes and the direction of travel is changed.
https://www.flickr.com/gp/r_walther/4T2220JB4Z
And if the drive car now simply so coupled without the other TF that wants what would then be displayed because I think both drive trains must be in clutch mode
Sorry, I can’t answer the freak because I don’t know the vehicles.
He must confirm the train association
What if he doesn’t do this or what will be displayed?