What is your opinion?
(No Ratings Yet)
Loading...Similar Posts
3 phase motor no longer works?
Hello! I have two three-phase motors with the corresponding boards… unfortunately, both have the exact same error. I tested the motors, installed them, and tested them again. Both worked… Now, a day later, they suddenly stopped working… The parts pulse briefly and then nothing happens. They have three cables: green, blue, and yellow. I've tried…
Electrical engineering help test?
Hey, does anyone know what formula I can use to calculate this?
Sovol SV 01 pro which parts from Creality?
Hi, I know that some parts of the Sovol SV 01 Pro are from Creality, e.g. the auto leveling sensor. Now the heating cartridge cable is broken, and I have no way to solder it in place. Therefore, I have to replace the heating cartridge. Unfortunately, it turns out that Sovol's spare parts service is…
Outputs "HI" and "LO" on voltage generators: What is "plus" and what is "minus"?
Probably a glaring gap in my knowledge (though I'm not an expert). We want to use a so-called source meter as a voltage source. Polarity is important; HI and LO are the correct outputs, but I only know + and -. What is the current direction? (Nothing can be found in the manual. Both could…
Change cassette?
I want to buy a new cassette for my bike. Is it enough if I know how many sprockets I have and what brand the derailleur is?
Speedport Smart 4 has resampling artifacts when making phone calls oO?
Hello, I have very audible resampling artifacts (aliasing) on the router mentioned above. I rule out the telephone ("Fetap 791") as the culprit because it is fully analog wired and the same telephone works perfectly on a Speedport W724 and has clear voice quality in both directions. It makes no difference from which side you…
I don’t know the switch program now, but normally there should be room to run the wires behind the socket insert down.
If that doesn’t go, then turn left and right.
And then enter the socket insert with a nice small bow from below. Then you have more reserve.
The length of the coat in the can looks good.
In the case of UP sockets, it can be more practical to set the connections up, but there can also be more reserve in the can disappear.
Just a cleanly installed wet room socket, what opinion should you have?
So…
I immediately see two things you should do better.
For this, the lines are too short cut.
But I’ve been doing this since 1973…
Hansi
Hello,
put the wires behind the socket insert,
and clamp them from below.
And leave the PE vein a little longer in a loop.
Then there will be a very good note.
Hansi
This is a socket attached to a grid.
What kind of opinion do you want to have now?
Do you live on the moon or have you been born recently? This is a Schuko socket without cover.
That’s a can. Oo.
Yes
Open wet-space-Schuko socket.
my opinion. on the larger picture you can see more.
otherwise I can only recommend asking a question what you want to know at all
Your instructor’s opinion is crucial.