ByGorki900
I can shift up on my motorcycle (Honda CB500F) without pulling the clutch.
I just don't understand how that works, after all the thing isn't equipped with a quickshifter.
What I can say about this gear change is that when you drive slowly it is a bit rough but at higher speeds it shifts smoothly.
Can anyone explain this to me?
(1 votes)
Loading...When I was 18 and didn't know the theory for my driver's license, I had to drive with a driving instructor. I couldn't do anything at the time, and all the driving lessons were terrible because I simply didn't understand the theory. (I had about eight theory lessons when I started.) On top of that,…
I sold my car four weeks ago, and today the buyer contacted me and said the timing chain is broken and I have to pay for a new one. The purchase agreement (ÖAMTC) excluded the warranty and guarantee, and two days before the sale, the vehicle inspection was done, and everything was fine, and I…
What do I have to look out for when I buy an exhaust, with others it's just with EG-ABE road approval, with others there is nothing about approval or anything else, I shouldn't take them or, I'm the type of person who wants everything registered but preferably if it's registration-free. If it says something like…
So on a motorcycle, the inner, thinner tube with the insulation wool around it… What happens if you make the holes bigger? Does the exhaust just get louder or duller or what?
That you can drive with a trailer weighing over 750 kg. Which would have to comply with C1E.
Good bye! Is the discoloration on my fork (Husqvarna Te 250, 2016) normal? If not, how do I get rid of the discoloration? If that helps, the fork was leaking quite a bit. LG
Why? Because a motorcycle gear has a so-called shift roller, it is so good;)
A Quckshifter makes nix different from going off the gas, you probably do that too;D
When you get full on the gas, however, there is wear on the syncron rings.
Are you taking the gas?
If you don’t do anything other than a Quickshifter. By short gas removal, you release the power lock in the gear and can switch. The reason why it only works well at high speeds is because you do not generate enough load changes at low speeds. If the clutch is better, easy grinding is already sufficient.
If you’re under full load, you seem to have a pretty precise gear. However, this is quite important for wear and is not recommended. Without QS, you should take the gas away.
Without QS, you should use the clutch!
I don’t understand how to give an obvious beginner tips with which he breaks his moped due to lack of expertise and experience!
If you are working with the gas, you can easily turn up, and down at the motorbike without pulling the clutch, without charging the gear. If it works smoothly, everything is good.
Was in place also not my intention to do it always asked me just how this can be all this is
I am convinced that this does not damage the transmission. It’s nothing but the Quickshifter. And that the bikes with QS get all the gear damage would be new to me.
You can turn clean even if you just made the driver’s license. It’s not magic, it’s super simple. Everybody can. Just try out, then you can see how easy it is. And don’t worry, your bike won’t break it right away, even if you don’t get it right away.
goes with any mopped, high as down — just give fitting gas or take away, and at the transition point the gang is running over.
Toe tip under the control lever, remove gas, push toes upward, gas
It works with some feeling on every motorcycle.
Because motorcycle gears can be switched very well without pulling the clutch.