VTTC Tesla coil not oscillating?

Hello, I'm new here,

I recently tried to recreate Steve Ward's single 833a VTTC, and nothing happens when I turn it on; not even a fluorescent lamp nearby lights up. In the pictures, you can see which components I had to replace because I didn't have the ones from his circuit on hand. I used a neon sign leakage field transformer as the voltage source, which is regulated from 6300V to ~2kV with a Variac. The tube is the 833a. I set the capacitor/windings of the primary coil to the resonant frequency of the secondary coil (~382kHz, primary coil = 115.6mH), so that shouldn't be a problem. The feedback coil is about 2cm above the primary coil. I'm also interested in how this circuit is grounded, and I would be very grateful for your help, because I seem to be somewhat confused.

(1 votes)
Loading...

Similar Posts

Subscribe
Notify of
5 Answers
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
Andy7754
7 months ago

Ok, dann würd ich die Röhre einfach mal überbrücken (Testbetrieb), bei der Betriebsdauer wär ich aber vorsichtig, da müssten locker mal 200- 400 Watt oder mehr über der Primärspule (die dicke braune) liegen, die schmort sonst weg. Den Trafo für den Heizstrom braucht man dann auch erst mal nicht. Ich hoffe, die Leistung wird durch den ersten Transformator begrenzt.. (…) Beim Einschalten, Abstand halten und besser noch Schutzbrille aufsetzen.

Adipaul
7 months ago

Ich sehe hier kein Diac sondern ein Triac, den kannst auch mal Überbrücken, ich Vermute wenn die Röhre nicht schwingt wie ein Sender dann musst die Steuerspule Umpolen.

Flips100
7 months ago

Auf den Bildern kannst Du sehen, welche Bauteile ich austauschen musste, weil ich die von seiner Schaltung nicht zur Hand hatte.

Kann der Grund sein warum es nicht Funktioniert.

Immer die Bauteile verwenden die derjenige auch Verwendet hat. Notfalls den Urheber seiner Schaltung Kontaktieren und Fragen ob die Bauteile auch so dazu passen als alternative ,da man die Originale nicht bekommen hat.