Vga led rot und kein Display Output nach pc crash während cyberpunk 2077?
Mein PC ist abgestürzt, während ich Cyberpunk 2077 gespielt habe.
Er hat sofort versucht neu zu starten, aber es wurde nichts angezeigt und die VGA-LED leuchtete rot.
Es schien nicht zu überhitzten. Ich habe keine Daten, aber ich habe die GPU direkt danach berührt und sie war nur warm, aber nicht heiß.
Ich habe ihn ausgeschaltet, den Strom entfernt und ihn etwa 10 Minuten stehen lassen, aber es hat sich nichts geändert.
Ich habe einen CMOS-Reset durchgeführt, aber es blieb gleich.
Ich habe die GPU entfernt, wieder eingesetzt und alle Kabel überprüft, aber immer noch nichts.
System:
7800x3d
RX 7900XT
Gigabyte B650 Gaming X AX
32 GB RAM
Be Quiet 750W
Ich habe auf 1080p gespielt.
Ich habe auf den maximalen Einstellungen (Overdrive) gespielt, also mit Pathtracing.
40-60 FPS
Die Spielsitzung dauerte etwa 4 Stunden.
gestern das erste mal cyberpunk gespielt, etwa 3 Stunden lang.
Das System ist etwa 4 Monate alt und hatte bisher keine Probleme.
danke schon mal für die Hilfe
It seems that you have taken some steps to diagnose the problem, but it is possible that the problem is deeper. Here are some additional steps that you could do to fix error:
If none of these steps solves the problem, it might be advisable to contact the manufacturer’s customer support or to have the system checked by an experienced technician.
Hello, thanks for the quick feedback.
I have already checked paragraphs 1 and 2.
I don’t have another graphics card, but I’ll have the Cpu built-in graphics tomorrow.
The drivers were when I was playing at the latest.
by the cmos reset was reset to my knowledge after the bios.
I can’t test point 5 without a picture.
Point 6 I will test tomorrow if something else does not help.
Thanks for the help 🙂
Probably you have become victim of the motherboard dead by AMD 7800x3D processor.
Look here:
https://www.pcwelt.de/article/1795825/amd-ryzen-7800x3d-burnt-through.html
PS: Build the processor and watch it. The burnt place is clearly visible.
The error , at least for Asus, was fixed by a Bios update. The update limits the voltage to 1.3 Volt.
Keep asking if your bios were up to date.
If you don’t find a burned place, you might have been lucky.
Thanks for the answer,
so bios was up to date.
I have just removed the cpu and there everything looks normal, not looks kind of burned, but everything looks even and clean.
Great. I see the computer running again. :