I would like the lamp to light up after 2 seconds (time delay) by closing the normally open contacts (NO) -KM and -KT. But even though I've set everything up and wired it correctly, it still doesn't work. Do you have any idea how to make -KM and -KT close after a certain time?
Hello, I do not understand the contacts or the contact numbers on a time relay and how should I connect it
Hello, I want to install two mini fans near my bed. When I press a button, I want the fans to turn on and then automatically turn off after 15 minutes. If I press a second button (whichever is easier), I want the mini fans to stop immediately, interrupt the 15-minute timer, and reset it…
Hello, I'm interested in the connection to this timer relay. A1=L, A2=N, and B1 is the trigger contact, so far everything's clear. I'm interested in the contacts that then transmit the voltage to the device. I think 15 is a changeover contact, 16 a normally open contact, and 18 a normally closed contact. But where…
Good Morning, I have a problem. I have an amplifier with an on/off switch. When I turn it off, the amplifier doesn't turn off completely, and it consumes power. Because I have a battery in this amplifier, it runs out after a while, so I have a switch between the battery and the amplifier. The…
How can I wire time relays so that they always operate in opposite directions, and for an infinite time? RT1 should be activated for 5 seconds, then RT2 for 5 seconds, and this repeats indefinitely. I want to build a traffic light where two traffic lights always switch staggered. Does anyone have a circuit diagram?
I bought a time relay on AliExpress. Now I'm having a problem: when the module triggers, I get no output, no matter what I try. I've already tried the other two, and the same thing happens. Then I tried a different one, and that one didn't give me any output either. Here is the link…
Hello everyone, I need a time relay with the following properties: Input (coil) for 230VAC Potential-free relay contact (normally open or changeover) Ideal for DIN rail mounting Relay should pick up after an adjustable (short) delay Relay should drop out after an adjustable time OR when the 230VAC input voltage is removed I haven't found…