I have a Hercules Luxe moped with a Sachs 623 engine. About a month or two ago, I also changed the oil (and I actually bought automatic transmission oil) and checked the oil level today. A few days ago, the engine was actually running perfectly normally. The rear wheel did turn a little at idle,…
Hey, Because my spark plug keeps filling up, I need to adjust my carburetor correctly. Now I'm supposed to screw in the idle mixture screw all the way, but where do I find it?
I have my Hercules working great with the following setup: 70ccm/ 13.5mm carburetor/ and p3 with a gianelli exhaust. Now I'm having the problem that it just won't idle. I've noticed that the grooves on the needle (pictured) on the carburetor are worn out. Because that little washer sits on top of it, and it…
Hello, I have a question. My motorcycle always gets loud when I engage the clutch, even though I'm not accelerating. Does anyone have any idea?
Hello everyone, I have a Luxxon KSport X15. Unfortunately, it shuts off at idle because the idle speed is too low. Can anyone tell me where I can adjust this? Unfortunately, I can't find anything about it in the manual. Because of Corona I cannot visit the dealer at the moment (had to close).
Hello, my Honda Transalp XL 700 VA (without choke) keeps cutting out when I approach an intersection or something similar and depress the clutch. I think the idle speed is set too low. But where and how do I adjust the idle speed? YouTube explanations always mention the choke. But mine doesn't have a choke…
I have an XS 400 with a kickstarter. It starts when you hold the throttle, but how do I adjust the idle speed? There's a screw I noticed, but how do I tell if it's working?
Hello, my Honda always turns off the moment I take the joke out. I've already cleaned the carburetor.
Good day everyone, My motorcycle has been having some problems recently. Kymco Quannon 125 Ez: 2011 Kilometers: approx. 20,000 km My idle is currently at about 3,000 rpm, which is quite a lot. Furthermore, when I accelerate, the rpm rises quite normally but drops very slowly. I've attached photos of the carburetor and a video…
Hello everyone I have a Tomos Quadro and would like to increase the idle speed… How do I do that?
Hello, I have a problem with the carburetor (16n1) of my S51. I installed the carburetor today and, in my opinion, adjusted everything correctly, including the float. Now it's not idling, and even adjusting the throttle screw doesn't do much good. However, once I accelerate, it starts to rev extremely high and only stops when…
Hello, I own a Kymco DJ 50 S. It doesn't stay on when it's cold or stationary… However, when it's hot or warm it stays on. Any suggestions as to what could be the cause? 🙂