Because we couldn't find a tradesman to do the plastering, the tiler simply glued plasterboard to the brick wall and tiled it. My wife has now bought a wall-mounted vanity (instead of the floor-standing vanity she originally planned). Our tiler, the plumber, and even the electrician have already tried installing it, but the vanity fell…
I attached a plastic canvas to a soft Styrofoam panel with nonwoven wallpaper adhesive. It held. What didn't hold was the wall mounting. I attached a thumbtack to the plate with UHU all-purpose glue and then another 5cm wide layer of UHU and finally fabric tape over that and then attached the plate to the…
On my new running route, there's a bridge with tall, transparent panels that are supposed to protect pedestrians from the wind… What are those metal cables attached to the panels for? There are four cables per panel… Four corners, four cables…
Who here knows about knots? I want to use a rope to secure my caravan awning against storms. Initial situation: Rope (length not defined) Eyelet on the ground and eyelet on the awning Now I want to thread the rope through both eyelets, then tie a carter's knot as a pulley, and then tension the…
Hello, I'm looking for the designation and OE number for the clips/dowels or whatever the parts are called to attach the storage pockets to the (front) doors. These shelves, or rather door pockets, are attached through the trim to the required fasteners with self-tapping screws. It would also be helpful if I could get a…
Hello everyone I have questions about dowels for substructures. What material is appropriate for fire protection requirements when it comes to dowels? I'm aware that only anchors with fire protection approval may be used. Is this CNS A2 or CNS A4? Which is better and why? Thank you very much for your answer.
Good morning, It's almost time to put up the maypole again. My girlfriend has moved, and unfortunately, the large roof overhangs at her new house mean there's no reasonable place to put it. Now my two thoughts: Screw pipe clamps for a downpipe into the wall of the garage (height approx. 2.60m), into which the…
Hello, what's the best way to secure my aquarium hose at the back? So it doesn't break off. the hose leads to the external filter
Can someone explain exactly how the screw was attached to the sheet metal, or what type of attachment method was used?