ByTarik20
Hello there,
Today I went to the MOT and didn't pass. They found this error (PICTURE)! I then read all the control units at home with OBD Eleven. The device didn't find any of these errors!
Can anyone give me some advice, other than saying that I don't have to take the car to a VW garage because it's really expensive to have a new control unit installed?
Thanks in advance.
(1 votes)
Loading...I have to do a final project for school and thought I could build an RC car myself. Unfortunately, the school's budget is only about 50 euros. I just want the car to be roadworthy. But I don't know what I need. Could someone write me a list of the necessary parts? Thanks
Hi, I drive a CLA 45 S, but the exhaust is much too quiet for me. This is due to the new filters that are now required. I would like to install an Akrapovic exhaust. Here is the link: https://www.akrapovic.com/de/car/product/21159/Mercedes-AMG/CLA-45-CLA-45-S-C118-X118-OPF-GPF/2020/Evolution-Line-Titanium?brandId=25&modelId=1142&yearId=6174 My question is, will this cause problems with the TÜV (German Technical Inspection Authority)? Is…
Good morning, My first car is a Lupo 6X 1.0 petrol engine. I noticed early on that the engine wouldn't start when it was warm or had been standing for a short time. The problem was identified relatively quickly by reading the codes, and we replaced the fuel pump relay. Well, that was a bit…
Hello My car was recently repaired. After the repair, I noticed a defect that was caused by the use of a worn-out part. According to the manufacturer, the part in question always needs to be replaced, but the repair shop didn't do that. Hence the defect. The invoice was paid and only then was the…
Good morning, My Smart Forfour no longer displays the fuel level correctly. At first, the lines slowly decreased, then suddenly it showed full again, and so on. Additionally, it was very slow to fill up and kept clicking, even though several liters were still being added. I took it to the workshop, and they first…
Hi. I replaced the ignition lock on my tool carrier. Now the left and right turn signals and hazard lights no longer work. What could be the problem? It's the lock pictured (3 plug sockets) from BOSCH.
Who says you need to trade ECUs? The impermissible wheel size alone can already explain all three errors.
But in doubt, you can also drive to VW and only read the error codes without having to repair anything.
Thanks for your answer the wheel size has nothing to do with it I had an appointment with the TÜV 2 years ago and came through after the 2 years I am now back at the same TÜV with the same 18 inch tires and do not come through due to an internal error
Then let VW read and see what’s really going on.
Without the exact error code, all searches don’t bring you anything. Before you exchange the control unit, there are countless other points in the repair guide that you control beforehand.
Thanks believe it doesn’t bring much because as I did research, the whole control unit had to be replaced because even VW didn’t know what the fault is