Standheizung funktioniert nicht. Was tun?
Ich habe ein Fahrzeug mit einer Standheizung und dieser scheint nicht zu funktionieren.
Das Teil geht an und macht Standheizung Geräusche, die Pumpe hinten geht auch an und taktet, aber irgendwann nach so 5–6 Minuten hört es einfach auf und schaltet sich komplett ab.
Die Standheizung wird auch richtig heiß. Ich habe irgendwo gelesen, dass das nicht so sein sollte, kann ich mir aber schwer vorstellen.
Das Teil ist jetzt nach mehrere Versuche nichts gemacht, egal ob im heiz Modus oder Lüftung Modus.
In die Papiere steht zwar neben der Fernbedienung auch, dass es eine Vorwahluhr geben sollte, aber im Fahrzeug könnte ich nichts finden.
Kann es sein, dass das Teil wegen des warmen Wetters nicht funktioniert?
infos:
Webasto Thermo Top c
Mit Telestart T90 Fernbedinung
Of course, a heater does not heat when the outside temperature is higher than the set heating temperature.
When she gets hot, everything should be okay.
Is there a cleaning program? It should also run through 10-20min in summer.
That would be new to me, especially since the heating does not know the outside temperature.
If the heater is set to 24°, but the ambient temperature is higher, it should be difficult to fulfill its task. She’s going out.
The heater is latte as warm as it is outside, which depends on the water temperature in the engine, if there is something wrong it goes out early.
I couldn’t see that. However, I also only build webasto heaters. I assume that you have been testing this at another manufacturer, because the thermotop keeps the cooling water to operating temperature in the normal phase, an interior temperature sensor is purely optional.
How much degree set?
How much degree had the outside temperature where the car stood?
Outside it was 14 degrees, I can’t set anything because I lack the dialing clock.
Shouldn’t be. When the stepless control phase is reached, the heating power is reduced so that the cooling water does not overheat. You should listen to the reduced timing of the fuel pump. As long as enough heat is dissipated, the heating does not switch off before the programmed shutdown time.
If it allows the installed kit used, I would manually control the blower by testing and observe how the heating is.
throw on the scrap pile and buy new
such a bullshit!