Rauch nach Anschalten meines Anycubic I3 Mega?
Hallo, habe seit längerer Zeit mal wieder meinen oben genannten 3D-Drucker nutzen wollen. Ich habe ihn eingeschaltet und nach ca. 1 min hat er angefangen zu rauchen und es hat auch stark künstlich gerochen.
Der Rauch kam unter dem Drucker auf der linken Seite heraus. Dort dürfte das Netzteil liegen. Der Drucker funktioniert noch einwandfrei jedoch habe ich Angst, dass er in Flammen aufgehen könnte, wenn ich ihn unbeaufsichtigt laufen lasse.
Was ist eure Meinung dazu? Kann ich den Drucker bedenkenlos laufen lassen?
Woran hätte es liegen können?
Freue mich auf eure Antworten.
I might screw the printer down and look at the power supply. Often you can smell something burned or broken. Shouldn’t be too hard to open it. But necessarily take out the power otherwise there can be a power stroke if you don’t exactly know where what is and comes anywhere. If you then know that it is the power supply, buy a new and exchange it. There is a tutorial on the internet and if not ask anycubic support.
I just walked him, I’ll do it after that. Thank you.
I once had PC power supplies that also smoked, but still worked.
I advise to exchange the net part.