ByKeevHZ
Hi. I wanted to repair the PlayStation myself. But now I'm a bit confused. I couldn't loosen the old connection with a soldering iron… Now I've read that I should use a heat gun until the connections come loose. But I'm a bit worried that I'll damage the surrounding parts. 😀
My heat gun is set to 300/600°C. Can I really hold it there until the socket comes loose?
(1 votes)
Loading...Our 2004 VW Golf Mk5 has a problem. When the ignition is off, the upper brake light comes on, the rear door lock unlocks, and the rear window wiper moves slightly, although it no longer responds when the ignition is on (even if it only slides a little further). I'd appreciate it if someone could…
We bought a Stiga Estate 5102 H lawn tractor from a dealer last year. It had problems right from the start. When we got it, the battery was so weak that it wouldn't start. Battery charged, works. But there were also strong vibrations from the mower to begin with, but we didn't think much of…
Hello community Does anyone of you know how to make this part red, paint it/stick it/or how I would be happy about an answer n
Hello, I have a big scratch in my car for the second time. I'm looking for a camera that will monitor the car, ideally for as long as possible. Does anyone have any experience with this?
Hello, my dears, About eight weeks ago, I purchased a used car with a dealer warranty. About three days later, I noticed a severe rust spot and an oil stain underneath the car. I immediately reported this to the dealer, who promised to repair it. A while later, the repair was completed, but only the…
I want to start an apprenticeship at a Mercedes-Benz workshop soon and wanted to ask how they pay, especially in North Rhine-Westphalia where they are not obliged to have a collective agreement.
the
Nintendo Playstation
Playstation 1
Playstation 2
Playstation 3
Playstation 4
Playstation 4 Pro
Playstation 4 Slim
Playstation 5
can still be dependent on the model
Model number : CUH-1116A
I mean this is a simple ps4
do not ventilate because we do not want to position a temperature shock on the components, and mainbord horinzontal (see for safety with a water level app on the mobile phone after just put it on it)
Yes, it is possible with a hot air gun. But other structural parts zb should be protected with tape to prevent soldering. I myself, however, have always brazed such things with desolation. Then enough flow medium on the solder points and newly brazed
No way with the hot air gun. It’s too rough, and it’s gonna be all the other ones to braz from the board.
And the soldering of the new socket is therefore difficult, since electronic soldering tines with flux are not suitable for being processed in this way (solving tines melt and burning flux before reaching the desired soldering point.)
Buy a soldering iron with fine soldering tip to solder the soldering points. They’re not that expensive.
If you can’t buy a soldering iron, but you have a soldering lamp available, you can do it by moving around: take an old screwdriver, grind the one at the tip and gently pick up the one with the soldering lamp (possibly indirectly at the shaft) until it starts to accept soldering tines at the front. Then dip the tip and hold it again briefly into the lamp. The screwdriver is now your soldering iron.