New Geberit filling valve type Impuls 380?
Hello, after installing a new, second fill valve (I returned the first Geberit 380), after successfully filling and closing the valve properly, a little water flows in again after a few minutes. I can also hear a quiet hissing noise, just like with the first valve. What could this be? Or did I do something wrong during installation? The lifting bell is about half full of water, the rest is just air.
I hereby request helpful information
(1 votes)
Loading...
Hello,
You can try to set the float a little deeper then if the pressure of the seal on the valve seat is increased. You can also just check it by raising the float a bit, then you should stop ticking!
Hello, the different depths or I’ve always tried the same result, clearly if I lift the blue lever a bit rest in the box but actually the water pressure on the lifting bell should do that, but doesn’t work
here the attempt to show the video
https://www.veed.io/edit/849547f6-ba52-473f-b961-da31b40addc9?source=%2F Tools%2Fvideo sharing
Update – Fixed bugs, simple knowledge of physical concerns have contributed to the clarification after which I have let the procedures in the use of the toilet flush go through the head, was then clear the valve works only if further water in the sink is necessary to reach the set level, wiso then does not rise the water level in the box? because a steady minimum fine water jet was flowing which was hardly to see in the toilet I hope, through my detailed explanations, I can help to understand this problem of every man /woman.
Greetings from Pensionaer1950