Looking for a switching actuator with WiFi function?

ByAtom99

Hello dear community,

I want to operate a 3D printer that only has WiFi in a room without WiFi reception.

Therefore, I am looking for a switching actuator that can access the Internet via an Ethernet cable and set up a usable WiFi network.

I would then like to control this via the Fritzbox and supply the printer with power and WiFi and switch it off via the Fritzbox when it is not in use, so that it has as little or no standby consumption as possible.

Thank you very much for hopefully many great advice:)

Lg

(1 votes)
Loading...

Similar Posts

Graphics card – 8-pin slot but adapter included?

ByJonas892332

Hello everyone, I ordered the following graphics card: https://www.amazon.de/gp/product/B0B8YSZ42P/ As I can see from the pictures, this one has an 8-pin connector. However, it comes with an adapter with two 6-pin connectors. Which one should I use? Do I have to use the adapter? My PSU cable has two 6/8-pin connectors. It looks like this:…

Subscribe
Notify of
2 Answers
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
minimax11
minimax11
5 months ago

First, grid separation is the best power saving circuit. So: Plug pull if not needed…

Without Wi-Fi reception, use a device with Wi-Fi only if you expand the WLAN network. This goes with “WLAN via the power grid” or WLAN amplifiers. WLAN via the power grid: a device is connected directly via LAN cable to the Fritzbox. The second device then sends a separate signal with which you can operate the printer, provided that it is connected to the same phase after the current meter. So an independent Wi-Fi network…

0
Atom99
Author
Atom99
5 months ago
Reply to  minimax11

I have a dlan set, but I want to work completely without or with minimal standby loss. The set of Devolo consumes in standby both devices 8W Plus 1.4W Wlan socket to turn off the printer.

0