Hello ,
I wanted to know which way the cables should be connected? Here is my motor for the steering
Here are the two cables
How should the cables be connected? How do you tell which terminals are positive and negative? If you connect the steering differently than intended, will it work the other way around when you control it with the remote control?
(1 votes)
Loading...Hello, I could get a universal battery meter that also measures internal resistance. However, it also gets results from a thin, short piece of wire. Depending on the mode, the resolution is either 0.00001 mΩ or 0.001 mΩ. The former would probably be better for my purposes. Can I use this for troubleshooting PCBs? Compare…
Hello I know you'll laugh at this, but I don't care. Our Sony TV, about 12 years old, keeps turning off [restarting] when watching RTL. Sometimes it also turns off and the red indicator light flashes. Prime Netflix is no problem, and I can watch other channels, too. The problem only occurs with RTL. I…
I have a power bank and would like to understand it. Type-C (Output): 5V-3.0A / 9V-2.2A / 12V-1.6A Does this mean that the connected device "picks" the appropriate voltage? What I know is that V*A equals the power (W). But does this mean that, for example, my iPhone now always charges at 19.2W? Thank you…
I don't understand what this is about and what can you do with it?
Here, it talks about bridging the resistor, but I don't see any bridging because the current source IC was replaced by an open circuit. So, the current must return via R6, and no bridging took place. Why is bridging mentioned here? Additionally, I don't understand how the resistors can be short-circuited by the beta node?…
Probier es aus. Wenn die drehrichtung nicht stimmt, tausch die Kabel.