LED indicators just light up?

BySimonwr06

Hello,

I installed LED indicators on my Husqvarna WR 250. It obviously didn't work with the original relay. So I installed a load-independent one, but when I activate the left indicator, for example, the left indicators only light up (ie, they don't flash). The same thing happens on the right. I thought it was the relay, so I bought the second one. The exact same thing is happening. What could be causing this?

1 vote, average: 1.00 out of 1 (1 rating, 1 votes, rated)
You need to be a registered member to rate this.
Loading...
Subscribe
Notify of
3 Answers
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
c4thryngo5i55
c4thryngo5i55
5 months ago

Did you really connect the wires? In some flashers, the polishing is important when you connect it around, only the one that shines permanently. It can also be that you're off the grid at the wrong place. The correct connection of the flasher or relay can be found in the user manual or on the Internet.

0
Simonwr06
Author
Simonwr06
5 months ago
Reply to  c4thryngo5i55

So I've got everything right on the relay. If you mean the blinkers, I don't know exactly. Can you connect the flashers wrongly?

0
martinreschke
martinreschke
5 months ago

The original flashers have no mass. The LEDs always have 2 cables. With me the brown cable attached to it was not as intended mass. After jamming, everything went.

0