Good day everyone,
I have a Kenwood KDC-4551UB and have installed it.
It works as long as I don't turn on the interior lights or the low beams. If I do, the radio simply turns off.
the interior lamp has burned out.
I drive a 2010 Aygo.
I also swapped the yellow and red cables… now nothing works.
please help me…
(1 votes)
Loading...Hi, I (m15) want to watch the spectacle at the Nürburgring with my boyfriend (m15), but since I haven't been able to find anything specific, I would appreciate it if someone could help me. I would like to know if there's a cost to watch, and if so, how much it all costs. I would…
As a car renter, do I have to pay the excess if the landlord has not reported the damage to the insurance company, he himself does not have to transfer the excess to the insurance company and thus only wants to enrich himself with the excess from the renter?
Good morning, My first car is a Lupo 6X 1.0 petrol engine. I noticed early on that the engine wouldn't start when it was warm or had been standing for a short time. The problem was identified relatively quickly by reading the codes, and we replaced the fuel pump relay. Well, that was a bit…
Good day, Unfortunately, due to my current absence, I have not taken my new Mercedes to the Mercedes dealer for the small service A, but to an independent workshop that carries out service according to the manufacturer's specifications. There were no problems with the car either; it hadn't even done 10,000 km yet. Am I…
Hello, my Golf 6 beeps three times in a row when starting. The warning lights are all OK. What could that be? Does anyone have any idea what it could be?
Hello everyone I have a question I wanted to paint the attachments of my car but I always have the problem that after a few days the clear coat cracks and peels off. I have already tried 5 different clear coats from cheap to expensive but somehow it never turns out to be anything permanent…
Usually, the plug connectors have a connection to the radio which when the lighting is active gives voltage to the radio to influence the radio lighting.
With you, it seems to be anxious that the radio goes out.
I would just disconnect the contact
That’s a good idea. I’ll take a look at the instructions!
Light+ (yellow cable) is attached to the radio as a mass.
I already found the solution. The radio has two voltage sources once from the battery and once from the ignition and voltage source of the battery had been lost voltage so voltage drop.
the radio has gone out again and again. I put both lines on the ignition. So always constant 12V
You definitely did something wrong. Just let it be checked in the workshop, remote diagnosis is not possible.
So I couldn’t do much wrong, and a workshop might be a little too much effort for the old thing. But thanks for the effort!
Obviously you’re overwhelmed with it, there’s nothing left to you.
In many cases, remote diagnosis is difficult – or impossible. But not here.
Someone probably used light+ as a mass here.
Got it.
The connection of the battery was the problem (red cable ), as it lost voltage when the lamps were on. That’s how it always happened. I have connected the red line to the yellow yellow (ignition) and thus always 12V on both connections.