Keine Leistung bei hoher Drehzahl?
Moin,
Ich habe bei meinem Motorrad (Fantic Casa 125 bj. 2016 ) das Problem, dass bei kaltem Motor gar keine Leistung vorhanden ist, und wenn ich ca. 30 min gefahren bin… also es dauert wirklich sehr lange, ich im 3. Gang vllt bis 60 komme. Beschleunigt jedoch trotzdem vergleichsweise langsam.
besonders obenrum geht garnichts, ich komme mit viel Mühe auf 90kmh und wollte fragen was die Ursache dafür sein könnte ?
Motor zieht soweit ich es geprüft habe keine Zwischenluft, würde auf den vergaser setzten, hat da jemand schon Erfahrung ?
LG
I’m a quad driver, but I’d tap the carburetor. Just clean the nozzles.
Can’t be the engine compressed properly anymore. Can have various causes such as piston rings, cylinder head gasket, valves etc.
It was already at the contract workshop, but they sadly had no faint glimpse… I know that sounds stupid, but after an oil change, not even enough to fill up oil, that I wouldn’t have come 100km far, I wouldn’t have checked it with a buddy because he had refilled oil.
If too little to no oil was in the engine, it could also be that the engine had a piston eater. Would also match the symptom you mentioned. Look into another workshop and let a compression diagram of the engine do.
control air filter/suction system.
If it’s not, you have a problem with compression.
air filter or carburetor
You should check the carburetor. Possibly the engine overgreases by a wrong setting. Clean up the carburetor and see how your motorcycle will behave.