Hello everyone! I've had a speedometer problem on my Keeway Hurricane for a while now. I've checked and replaced everything (speedometer cable and speedometer worm gear), and I noticed that even with a new speedometer worm gear, the shaft doesn't rotate at all.
Hope someone can help me, thanks in advance!
(1 votes)
Loading...I always tightened the nut with a hammer drill, but now I can't tighten it anymore. I guess the thread is worn out. What can I do now? I don't want to get a new crankshaft because it's too much work.
Hello, …how big exactly is the tank connection on the Puch Manet Maxi S Type 300 moped…??? I would really like to know, as I need to buy a complete fuel tap for my moped because this one is unfortunately completely leaky…!!! Many thanks in advance LG
The Aerox has always been the high end stuff for me, but is there a better scooter than the Aerox?
Good evening. Here's the problem. I used to be able to start my scooter normally using the electric starter. Suddenly, it just died and leaked a lot of fuel. I replaced my vacuum valve because it was defective. Now it's not leaking fuel anymore. Despite everything, I'm having the problem that I can't get it…
Hello, I was riding my Sachs ZZ 125 yesterday, and then it died while I was riding and wouldn't start again. It would start every now and then, but then died again after about 10 seconds. It has 9,000 km on it. I tried a new spark plug today and cleaned the carburetor, but nothing…
Hello! That sounds like a difficult problem. I have had similar problems with my Keeway Hurricane and can give you some tips.
First, check the cable connections between the tachometer shaft and the tachometer. It may be that the cables are not properly connected or that the cables are damaged.
Secondly, check the cable connections between the tachometer and the battery. It may be that the cables are not properly connected or that the cables are damaged.
Thirdly, check the cable connections between the tachometer and the engine. It may be that the cables are not properly connected or that the cables are damaged.
Four, check the ignition key. It may be that the ignition key is defective and therefore does not establish a connection between the tachometer and the motor.
Fifth, check the tachometer itself. It may be that the tachometer is defective and therefore does not establish a connection between the tachometer shaft and the motor.
I hope these tips will help you solve your problem. Good luck!
Thanks for the detailed answer! I’m going to try a lot today.