ByUweopa
I'm looking for a USB camera to monitor my 3D printer. It should have a good resolution at a distance of about 10 cm. Can anyone recommend one? I have a Renkforce RF 100 XL. Thanks in advance for any tips.
(1 votes)
Loading...The error message won't go away even though I've followed the YouTube instructions and reset the purge counter and other settings. They're at 0, but this error message still appears. How do I get rid of it?
Actually, everything is already in the title. Perhaps one of you has already had experience with this and can help me figure out how to get it done quickly and easily. Thank you very much
I have a multifunction device: Canon MX 495. When you send a fax, the device first scans…and then sends the fax! My question is: where (if at all) are these scans stored and how can I access them afterwards? Thanks!
As you can see in the image below, the layers above the support structures are printing poorly or almost not at all. Apart from these, however, the print is flawless. How is this possible? I have already tried printing temperatures of 200-235°C and nothing happens. I use a 0.8mm nozzle with 0.2mm layer height and…
Hello, I tried to print a letter U today. Can anyone help me figure out why my printer prints so well for the first few layers and then suddenly this happens? I would be very grateful for an answer. Best regards, Luca
Hello everyone, I'm planning on getting a 3D printer and wanted to know what you think is the best printer for around €300. I already have some knowledge of 3D printers, but I haven't owned one yet. Greetings Lukas
I have nen raspi hanging on the printer who also connected the camera (octoprint). I’ve taken it easy – it’s enough to see if it’s bad or not.
https://www.amazon.de/SunFounder-Raspberry-640×480-Resolution-Windows/dp/B078Y5N9X2
I’ve got a simple one too, so what to record for the video.