Similar Posts

Subscribe
Notify of
33 Answers
Oldest
Newest Most Voted
Inline Feedbacks
View all comments
Speckwampe537
1 year ago

As it can be seen that it is a 20-year-old construction carnival, I can say: Actually, it should be slandered. They’re not really pinching with the unbalance control.
What’s the flash?
Did you accidentally choose a flush stop?

Speckwampe537
1 year ago
Reply to  panduxa593

Okay.. Gives several options:

  • Motor coals worn
  • Engine defective
  • Electronics

Since this machine is about 20 years old, a coal exchange would be worth noting that of the engine or electronics.

On new devices I recommend Miele (but only the OHNE TwinDos) and Bosch/Siemens.

Unfortunately, the other manufacturers have extremely good quality and so have left behind. The worst are the new Samsung, LG and Bauknecht devices, as Bauknecht belongs to Indesit meanwhile, Indesit is miserable.

That’s why Miele or Bosch/Siemens.

Miele is the highest quality and makes the least problems (except TwinDos, therefore one without taking). Bosch/Siemens has sometimes smaller problems, but for that the cheaper than Miele is the price/performance as well.

HobbyTfz
1 year ago
Reply to  Speckwampe537

There is no defect, read my answer

Speckwampe537
1 year ago

Before then, however, try to spin again without washing and to spin with a normally filled drum.
Other

Hello, just found at OTTO. Check out this article:

https://www.otto.de/extern/?page=%2Fsiemens-wäsche-wm14nk23-8-kg-1400-u-min-1717771967%2F%23variationId%3D17772286&clickin=webshareapi&campid=P.AC-O.MP-SHAS-OW.T-RFA2150

Speckwampe537
1 year ago

No problem. What would your budget be if I could ask? Then I would look for a good machine for you

HobbyTfz
1 year ago

Hello panduxa593

If only a little laundry or a large piece of laundry in the drum is then a great imbalance is created and the machine reduces the speed when spinning or it does not begin to sneak at all.

In this case, if you still fill the drum with towels, the machine will also throw. When you’re full of drum, the laundry can split up better and the possibility of unbalance is greatly reduced

Greetings HobbyTfz

Speckwampe537
1 year ago
Reply to  HobbyTfz

It’s possible. Here, however, all the centrifugal LEDs flash. This is usually not caused by

HobbyTfz
1 year ago
Reply to  Speckwampe537

In any case, it should fill the drum with laundry, then it will be thrown

HobbyTfz
1 year ago

If the noise comes from the engine then the drive belt may have jumped off

HobbyTfz
1 year ago

Check the socket with a hairdryer, then try another restart

antiaes
1 year ago

You’re supposed to be half-full. Maybe it’s also a technical defect.

HobbyTfz
1 year ago
Reply to  antiaes

There is no defect, read my answer

antiaes
1 year ago
Reply to  HobbyTfz

So the first part of my answer…

Speckwampe537
1 year ago

There are several possibilities.
I don’t know when I get the expertise from a good question. Been active here for a year

antiaes
1 year ago

Expert HobbyTfz Is it different?

HobbyTfz
1 year ago

Too little

Speckwampe537
1 year ago

That’s right. Only then do not flash all LEDs.
Once washed a single very thick sweat jacket. It’s really heavy wet. But my machine was thrown (Miele, built in 2022)

The machine to be seen here at the questioner is a 20-year-old construction machine. They’ll let them be unbalanced.

Moreover, because of unbalance, not all LEDs would flash!

antiaes
1 year ago

Cage: If only little laundry or a large piece of laundry in the drum is then a big imbalance is created…

Speckwampe537
1 year ago

No, you can also wash 1/4 or 2 parts. I’ll do the more open.

anwesende
1 year ago

if there is too little laundry, the unbalance control can no longer compensate.

m.f.G.

present

florestino
1 year ago

You can also throw little laundry. It can’t be. It must be a mistake.

florestino
1 year ago
Reply to  panduxa593

Have you ever tried to start a separate spin?

HobbyTfz
1 year ago
Reply to  florestino

There is no mistake, read my answer

HobbyTfz
1 year ago

There is no defect, read my answer

Speckwampe537
1 year ago

Options:

  • Motor coals worn
  • Engine defective
  • Electronics

Since this machine is about 20 years old, a coal exchange would be worth noting that of the engine or electronics.
On new devices I recommend Miele (but only the OHNE TwinDos) and Bosch/Siemens.
Unfortunately, the other manufacturers have extremely good quality and so have left behind. The worst are the new Samsung, LG and Bauknecht devices, as Bauknecht belongs to Indesit meanwhile, Indesit is miserable.
That’s why Miele or Bosch/Siemens.
Miele is the highest quality and makes the least problems (except TwinDos, therefore one without taking). Bosch/Siemens has sometimes smaller problems, but for that the cheaper than Miele is the price/performance as well.