Häkelanleitung brauche Hilfe?
Hallo Ihr Lieben,
leider verstehe ich dies Anleitung nicht ganz.. Das fertige Häkelteil sieht leider nicht so aus wie es sollte… Vielleicht könntet ihr helfen:
Rd1 fM in MR
Rd2: 11LM, in der 2. LM von der Nadel aus beginnen und 10 fM zurück in Richtung MR häkeln, fm in MR, LM, wenden.
Rd3: 10 fm ins hMG, 6 LM, in der 2. LM von der Nadel aus beginnen und 5 fM häkeln, 10 fm ins hMG, fm in MR, LM, wenden.
Rd4: 15 fm ins hMG, 6 LM, in der 2. LM von der Nadel aus beginnen und 5 fM häkeln, 15 fm ins hMG, fm in MR, LM, wenden.
Meine Frage ist da expliziet, fange ich dann beim wenden wieder in der fM im MR an oder bei den fM davor?
(2 votes)
Loading...
If you’re crocheting back to the MR, your last solid mesh must be pierced into the MR. You didn’t do that. That’s why to this straight side the “Treppen” is about.
So your last mash when you come back is pierced into the MR and a solid mash is crocheted. Then you turn with an air mesh and the first fixed stitch of the new row is crocheted into the last fixed stitch of the previous row.
I understand that with “fM in MR”, i.e. a fixed stitch in the magic ring, the round is finished and with “LM, turn” is passed over to the beginning of the following round. The number of stitches suggest that you then puncture into the last fM which has been crocheted into the MR before the fM.
Thank you.
That’s exactly what I’ve done so far, but then the piece is more of a treble than as round as on the picture.
In the picture you can only guess because the stitches are very unsharp. With the image of your part next to it, you can see more. I don’t even know where in this picture the first row and the MR should be. I suspect the beginning to the left in the top, but I can also be mistaken.
The steps on the left correspond to the instructions. There you can change quite a bit, except you would cover the steps with a row fM and always put some half sticks where it goes down.
If I compare both pictures now, I guess the MR between the crochet needle and the corner left/low. This would match the description and then pull this edge together for rounding. You should now, the logic of the increases, be finished in the sixth “rude”. Two rows fM are crocheted in each round, but only one stitch is made in the MR. Therefore, it seems that at this edge each second fM is too much.
I fear that only cautious pulling without needle and repetition from the end of row 2 (fM in MR, LM, turn) leads to the right result if the short edge does not result in the desired result. For practicing, you could use a simple ribbed yarn to turn to five fM of the execution with an LM and crochet 5 fM of the rear row to test the edge on the MR.
I added another picture. At present, the MR is with me on the right side so where it is Breit.