Grafikkarte dreht grundlos immer öfters Lüfter auf Maximal?
Hi,
ich habe seit schon etwas Längerem bemerkt, dass meine Grafikkarte manchmal wie aus dem Nichts die Lüfter bis aufs Maximum hochschraubt. Das ist ziemlich blöd, da sie mit ihren 3 3200 RPM Lüftern damit lauter als ein Staubsauger pfeift. Erstmals habe ich das in Star Wars Battlefront II erlebt, wenn Lichtschwerter gezeigt wurden. Irgendwann geschah das auch in anderen Spielen und immer häufiger. Nun mag man denken, die Karte hat ein Problem mit der Kühlung in rechenintensiven Szenarios. Dem scheint jedoch nicht so zu sein, da ich die Temperaturen in HWInfo genauestens überwacht habe und keinen Temperaturanstieg in Zusammenhang mit der Lüfteranomalie feststellen konnte. Es handelt sich um eine RTX 4080 von Inno3D und sie ist jetzt ziemlich genau zwei Jahre alt. Denkt ihr, ich sollte sie mal aufschrauben und gründlich von Innen putzen und die Wärmeleitpaste erneuern, auch wenn es äußerlich nicht an der Temperatur zu liegen scheint? Außerdem erlischt, soweit ich weiß die Garantie, wenn ich daran herumschraube. Was meint ihr?
Well, if it’s very loud and it’s 2 years old, it might be possible to use a new heat-conducting paste.
Warranty is usually over after 2 years, so be careful to disassemble and change thermal conductivity paste, and in each case the fans and coolers should clean it again.
I’ve got old heat-conducting paste from my CPU. Can I take them? And do I have to replace the thermal pads on the VRAM or can I use them further? I also forgot some technical details on my question. My core temperature is under load at 80 degrees, hotspot at 110 to 120 degrees and VRAM at 65 degrees.
If heat-conducting paste is still good in the tube can use those where heat-conducting pads on because VRAMs still need to be soft but the temps of VRAM is ok, only the temps of GPU chip are bit too warm from 83 degrees Takes the down because Hotspot I always ignore
I had the same case. to build up the WLP correctly
Not even the force of my cordless screwdriver was sufficient to release the screws from their thread. Instead, the whole graphics card has moved.
Two screws cannot be released by force. Think the project has already failed
Look at Youtube technikkeller on he makes this very common before you completely disassemble the map
Okay, I’ll get to work. Do I have to be scared? I’ve done this before at my old 2060 and it looks clearly smaller and less complex. So can I break a lot of things and I have to pay attention to what?