Does this tunig work?
Hello
I once saw a video on how to tune a moped. A guide, then.
This was: Rub a chain link with a 7 Gauss strong magnet.
Then place a wire (3 OHM) with 7 turns around the chain tube.
Then another 42 wraps around the cone on the exhaust.
I wanted to ask if this works.
The manual says that every time the magnetic chain link runs through the 7 windings of the hose reel, an exhaust suction is created at TDC.
Thank you in advance
Salmon
The instructions are incorrect. You have to take a magnet that you stick to a fishing line at the front. Then you mount a second, front on the fork. The magnets pull on and the moped is driven by magnetic force.
Both systems are comparable. But both have the disadvantage, they don’t work. But at least the second method is easier to install.
Tellenone
works 100%, but you have to bury a black cat at the cemetery wall at midnight of 29.02.
Sure it works. That pulls you out of the bag when you get gas.
..then he is not as foldable as Herbert Knebel’s….
There are no more pure mofas, but only throttled small motorcycles. Throttle out: done.
This is such a cheap method. This is much better with the donkey and the tube: screw the front end of a donkey at the front of the mofa, attach a fishing to the handlebar and hang a tube in front of the donkey with the help of this fishing. He runs like there’s no morning.
If you also screw the rear end of the donkey, you even have all-wheel drive. With the excrements of the donkey you can operate a biogas plant and then run with Methan-LPG.