ByJanus342
Hey guys,
I wanted to ask where I can buy new rear rims for my bike online (27.5×2.10, 54-584, 8-speed). I've already looked it up myself, but I don't understand all the information. Unfortunately, many of the spokes on mine have come loose.
(1 votes)
Loading...Is there a possibility to have a tapered suspension fork that has 1 1/8 inch at the top and 1.5 inches below to install them using a headset adapter in a frame that is only designed for 1 1/8 forks. In other words, a bearing would need to be installed at the bottom—an EC bearing…
Hey guys, I just accidentally shifted from fourth to third on a main road even though I wanted to be in fifth gear… annoying What could happen? I'm a little scared Greetings :/
Beautiful good day, I wanted to ask which valves the photos refer to. Unfortunately, I've read about it, but I've never been able to identify them. Thanks in advance. Best regards
Hi everyone, can you do it like this?
Hello. How can you calculate the voltage u or current I in a circuit without a resistor?
27.5 – A generic name for tyres with an approximate outer diameter of 27.5 inches and an inner diameter of 584 mm.
2.10: Thickness of your tyres in inches
54: Thickness of your tires in millimeters
584: We had already. This number must be consistent with both the tyres and the rim.
8-fold: 8 tooth rings. Then there are also toothed ring cassettes with 9 of the 10 toothed rings.
Felge: Only this Ring between tyres and spokes. You’re looking for a wheel, a rear wheel, no wheel.
What is missing from you is the mouth, that is, the inner width of the rim. It should be at least 19 mm for your tyres.
You can spawn with a Spoke keys pull back.
So first thanks for the extensive answer. With the spawning key, did you hear that you shouldn’t do it yourself because the ripening can get an 8 or can you do it yourself?
You can try it! If you’ve never done it before, you should take care of it and adjust to take longer.
If no spawnings have been broken, I would only easily attract the spokes at your place and leave the actual clamping and centering of a workshop. If you go there with a clean, disassembled, single impeller, it can’t be expensive.
Online is also difficult. I’d go to a big bike store and take the bike. Advice is also free.
Maybe it doesn’t have to be a new purchase, a radwerkstatt can also draw. This may be cheaper:-)