ByManqen00
(1 votes)
Loading...Hello, the tire tube on my E Scooter was replaced. According to the manufacturer, the minimum pressure was 2.4 bar. Now I only have 2 bar on it and the tire is hard as a rock.
What type of load carrier is shown in the principle sketch? I'm getting positive charge carriers because I have to use my right hand to get everything right. Is that correct?
Dear Community, How much would you pay for a Simson Schwalbe, Habicht or Star that is in reasonably good condition and has papers? Thank you. greeting
Hi, when I adjust the fuel mixture on my scooter so that it runs smoothly, the spark plug turns pretty black. But if I then lean the mixture, it stalls at 2/3 of the throttle to full throttle. However, if I pull the throttle slowly and it builds up speed, I can eventually easily pull…
I recently rented an e-scooter for the first time. I was done and wanted to end the ride, but then I noticed that there are green-circled zones where you can park them. I don't really know how, but the ride ended without me being in the green zone. I looked into what happened next, but…
Hello everyone, I own a Speedfight 2 and I had the engine, cylinder, piston and crankshaft replaced because the teeth on the crankshaft were worn out. After the overhaul, I have a compression of 9 bar. I also installed a new battery, carburetor, fuel tap, and diaphragm. The problem is, when I drive, the scooter…
You can share the cable in one place, solder a longer cable piece, solder the switch and then protect all soldering points with shrink tubes. Because of the switch, I’d put another strain relief.
This is a plug connection. If you pull this off and insert a line with the same plugs at the ends, you can put the switch where you want.