Does this mesh wire fit the Vapefly Siegfried (vaporizer)?
Hello to the steamers 😀
I'm new to changing diapers myself and need some help.
I have the Siegfried from Vapefly since today and, based on recommendations from the internet, I got the following mesh roll: VandyVape Mesh Wire 300er SS316L
Unfortunately, this one is completely different from the included mesh plates. Its tight mesh makes it very flexible—almost like gift ribbon—and wider, too.
Question is: Can I just cut them to size or what do I need to pay attention to in order to get the right resistance :D?
(1 rating, 1 votes, rated)You need to be a registered member to rate this.
Loading...
Hello Skys888
I also have this "gift tape" by Vandy Vape, which you can in principle install each Mesh vaporizer after suitably tailored. In the case of mesh, however, it is generally necessary to be extremely careful when annealing. From 10W it burns if you don't watch.
Yes, but only from one side as the cut edge can fray when you thread the cotton.
If you use a regulated battery carrier, the resistance is not so important.
But I would have recommended you these finished sheets. They also last relatively long. I'm sure I've got mine in the last year.
Hey thank you for your answer 🙂
Let me order those things. Which one do you think is best?
I still have the role here.
How can I find out how much watt I have to adjust if I have cut myself a bit of the roll if not over the resistance?
The power is required for a self-winding evaporator always try. About the Resistance nothing to determine.
I use stainless steel mesh strips (SS316L) as I vaporize in TC mode. However, they do not necessarily have to fit in Siegfried. You should check this before.