Broken engine?
I drive an Aprillia Sx 125 and am currently changing my cylinder and piston because they are simply worn out.
have about 40,000 kilometers on it
Is it normal for such small engines to give up the ghost at this mileage? And why?
I drive an Aprillia Sx 125 and am currently changing my cylinder and piston because they are simply worn out.
have about 40,000 kilometers on it
Is it normal for such small engines to give up the ghost at this mileage? And why?
My Simson S53, built in 1998, only goes about 50 km/h and everything is fine with the cylinder, carburetor, and gearbox. What is different compared to the S51 and S50, and what can be optimized?
I own a Kawasaki Ninja 400 and want to convert it into a stunt bike. To prevent the entire fairing from getting scratched every time I crash, I want to buy a suitable stunt cage/engine guard. Now my question: Is the Crazy Iron ( https://crazyiron.lv/product/crazy-iron-cage-pro-kawasaki-ninja-400-2018-2019/ ) legal in Austria? Or at least with an individual…
I'm looking for an old enduro that was built before 1992 and has 50 cc and can reach 60 km/h. I'm not quite sure if there are any enduros from that time that can legally reach 60 km/h, but if anyone has any suggestions (make, model) that would be very helpful (An example is the…
My T4 campervan had slightly worn ball joints. They were replaced. At the same time, the alignment was readjusted at a second workshop with a tracking record. After only 1,500 km, the front tires, which were still in very good condition, were both worn down to the outer wire, and the old tread remained on…
My job allows me to be quite flexible and I can do a multi-day tour at short notice. The destination is Mallorca. Unfortunately, my research has revealed that the highway from Lyon to Barcelona is said to be very crime-ridden, from car break-ins to scams. Is it safe to start such a tour alone, or…
If this is a two-stroke engine, then a lower service life there can be explained by lower lubricant feedability compared to a 4T engine in the area of the cylinder fitting.