ByBalousio
Good evening.
I have a problem here that might come up in an exam, and I'd like to know if I've calculated it correctly. J is the moment of inertia, Fz is the rope force, and Fr is the friction force that sets the pulley in motion and generates torque.
(1 votes)
Loading...Hello, I'm planning to measure the humidity with an Arduino. I've ordered a resistor that changes its resistance value depending on the humidity, the SYH-2R. Using a voltage divider, I want to measure the dropping voltage with the Arduino and use it to calculate the resistance of the SYH-2R. This calculation will then be converted…
What can be said about the inertia of electrons in a cathode ray tube? I know this question sounds a bit strange, but my worksheet on cathode ray tubes asks for completion of sentences, and it just says "The inertia…" Does anyone have any ideas? Lg
So how should one understand what is warm and what is cold from where and so
I completely rebuilt the engine of my GZ125 (new crank, pistons, connecting rods, etc.) after it briefly ran on too little oil 3 years ago and since then had a connecting rod failure that worsened this year and almost 3,000km later. Now the engine doesn't sound good, and it's ticking/clattering in sync with the rpm,…
I'm preparing a physics study sheet and have forgotten a gap on my worksheet. The topic is "The Coil" and "Alternating Current." Does anyone know what to fill in the gap? The stronger the permanent magnet, the ______ the induced voltage.
I’m coming to the same.
Thanks for the time 🙂