Hello everyone,
I have the following problem: on my brushless DF Models Destructor MT only the front drive works.
I suspect that it is not greased enough.
it is almost as good as new…
Could you please help me? Thanks in advance 🙂
(1 votes)
Loading...Hello, My problem is, I need a "clay" with which I can model something or make an impression, and which, after curing, is exactly the same size as before. I've heard that modeling clay shrinks slightly when fired. Is a simple air-drying clay sufficient, or is there a special one for that?
For my models I mixed some of the plastic with my glue to make it soft and to close the gaps etc. Now the plastic is no longer hard but has a putty consistency and no longer sets?
Hello I have been interested in model railways for a few years and have a few H0 locomotives. But unfortunately I don't know anything about remote-controlled driving, so I need help on how to get my locomotives to run without throwing 9000 euros out the window and without what happened to my Piko locomotive at…
Hi, I own an Ender 3 v3 SE and wanted to ask if anyone can recommend some cool filaments to me.
I found an old Robbe Milan 19789 in the basement, but it's missing the servo and the technical stuff. Does anyone know where I can still get it? So mainly the controls.
Hello! It is annoying that the all-wheel drive of your DF Models Destructor MT does not work. There are various possible reasons for this. It could actually be that too little fat has been applied, which can lead to friction and a blocked all-wheel drive. It is important that all moving parts are well lubricated to work smoothly.
Another possibility is that there is a problem with the electronic components. Check the connections and cables to make sure everything is properly connected. It could also be that a motor or ESC (Electronic Speed Controller) is defective and must be replaced.
It could also be that the differential gears of the all-wheel drive are blocked or damaged. Check them for dirt or damage and clean or replace them if necessary.
If you are unsure of how to fix the problem, I recommend that you contact a specialist or the customer service of the manufacturer. You can give you specific instructions and support to solve the problem.
Good luck repairing your DF Models Destructor MT!
Know the model now only of images from the internet, therefore no exact diagnosis possible, but I exclude too little fat! I’d rather express the guess that a grub screw has loosened in the drivetrain, or something in the rear diffuse has loosened and twisted through. How did you find that the rear axle is not driven??
Hello, by turning through the front and when I lift it up and give gas, just turn the wheels in front…
OK, that actually sounds like a gear problem. Are you skillful? Then break it apart just the rear axle, you will find the mistake! As I said, I also type a loose grub screw, possibly directly on the cardan shaft, that would be good, then you don’t need any spare parts. Pull back and eat well. Otherwise, depending on the construction, it would still be possible to have a rotating differential, or if broken teeth run very badly in the gear, or sheared drive shafts.