PS5 controller?
Can someone help with the so-called stick drift what could be done
(1 votes)
Loading...
(1 votes)Loading...
(1 votes)Loading...Similar Posts
How much electricity does this doorbell use approximately in a whole year?
I always wonder: if no electricity was used in the house, would the electricity meter even move a centimeter?
Table press electropneumatics?
Hello, I have a small problem. I need to create an electro-pneumatic circuit diagram for a table press for school. It's supposed to work with limit switch rollers, but I can't quite figure it out. It would be great if I could get some help. I'm attaching a picture.
Vape 0% liquid but still works?
It's a bit complicated. The vape is empty, but before that, it didn't always work perfectly. I kept blowing from the back to get smoke out, but no smoke came out. I then threw it on the ground and it worked again. 😂 But by constantly blowing from the back, the liquid kept going down….
Alternating indicator tasks?
ByDemiurg3
Hello I need help with these two alternating indicator tasks I don't understand
Why doesn't a generator have a check engine light?
Bypaulgfrg
Hello, A bit of a strange question, but why doesn't a generator (petrol or diesel) have an engine warning light? There's usually only the red oil can, which lights up when the engine is low on oil. But how does that tell you about things like misfires or poor emissions? Generally, the engine warning light…
Minimum distances between tube sockets and PCB?
Hello everyone, Are there any empirical values or even regulations as to how large the minimum distance between the solder pads for tube sockets on circuit boards should or even must be? Voltage range up to 350V DC, maximum current 100 mA.
You could change the dead zone in the settings, however, this is less recommended so your controller only
for example
Hall Effect sticks react immediately after moving
At a dead zone
It’s different you have to imagine
| For example, 10%
| | And this as example 20
The first line is the middle of the stick you push the stick now to the left would react the higher dead zone later with a higher sensitivity
Unsuited for shooters when you play a lot as Casual goes clear
But I can only recommend Hall effect sticks that you can either solder yourself or buy a finished controller
buy and disassemble exchange stick
Or sell for 20€ and get a new controller.
Lg
Enlarge the dead zone in the controller settings (do not worry too much, otherwise it becomes exhausting).
Where can this be found in the setting?