Speedfight 3 piston seizure cost?
Do you know how much it could cost without the workshop but only material ^^
(1 votes)
Loading...
(1 votes)Loading...
(1 votes)Loading...Similar Posts
Voltage regulator is stuck?
ByJorgo202
Hello, I have a 2003 Yamaha Aerox LC and the voltage regulator is held in place with a Phillips screw that has a nut on the back. I've tried with all my strength to remove it, but it's too tight. How can I get it off?
Adjust Simson clutch?
Hey, my S51 drives normally in first gear, but when I shift gears, it cuts out. It's also pretty hard to pull the clutch lever… I wanted to adjust the nut behind the black plastic screw, but when I tried to unscrew the adjusting nut, the rear wheel moved and it sounded like it was…
Would you prefer an e-bike or a scooter?
ByAndi733
My commute is about 5km each way. What would you choose? It is a price/benefit analysis
50 cc scooter cracking in the front wheel?
Hello dear people, I have a new, two-month-old Peugeot Rollet 50cc, and for some time now, I've noticed a creaking noise coming from the front wheel. I've taken a closer look, but I can't find anything. However, I'm a layman. The creaking noise always occurs exactly after each rotation of the wheel. The wheel itself…
Does a KTM SX 125 have more horsepower than a KTM exc 125?
Hi, I wanted to ask which of the two cars mentioned has more horsepower, because I've already found examples of both on eBay with over 40 hp and I'm just interested in which one would win in a race???🤔 PS. My SX has a DEP manifold and a Pro Circuit rear silencer The exc from…
Bubbling noises when kicking?
Good morning, My scooter died while I was driving, and now I'm troubleshooting. The carburetor looks fine. The air filter box just came off. The spark plug looks good. The scooter didn't make any noise when I started it. But now it starts bubbling when I start it? Is that good or bad? What's wrong?…
Complete set (cylinders, pistons, rings, etc., seals) you get from the bay for the Speedi from 25€, would not take the cheapest now, but something in the middle price segment. Take 50-100 €.
thanks for the answer helps me much more 🖒
I have no picture of what it looks like. That is why the full programme:
-new cylinder (or old grinding, honing)
-new piston
-new piston rings
-New Pleul (or crankshaft)
-new needle bearing
-new piston bolt