3D Drucker macht komische Geräusche?
Mein 3D Drucker macht komische Geräusche die sich anhören als wäre da Sand drinnen. Als in meinen Zimmer bei Reparatur arbeiten ein kleines Stück aus der Wand gefallen ist und dann alles voller Staub war begann er Geräusche zu machen. Ich habe ein paar Wochen später was ausgedruckt und alles war Super. Nur wären er druckt macht er Geräusche.
Sollte ich mir Sorgen machen oder ist es nicht schlimm. Ich weiß das 3D Drucker sehr empfindliche Geräte sind aber er druckt super und läuft perfekt. Also sollte ich da was machen?
danke
Dust will have come into the camp.
I’d clean the bars with a cloth and then re-oil with some balistol. Or sewing machine oil. The noise disappears after some time when the dust remains adhering to the oil and is pushed together by the carriage movements. Then you see a black ring on the bars. wipe this one again.
The same also applies to the threaded rods.
Do not use fat. Fat holds dust and sand and is more counterproductive.
Therefore, chains are also oiled and not frozen.
Hello,
try the movable parts with compressed air. They are available as cans to buy in the construction market.
Noises are never good, as there is something looping or blocking. So you have material abrasion and sooner or later wear.
Otherwise, expand and clean the bearings. Behaves similar to a bicycle (hub, circuit)
Vg